Gel Nail Lamp

1. Remove the Gelous Gel Nail Lamp and DC Adaptor from the packaging.
2. Remove the blue film on the base plate and the clear film over the timer.
3. Connect the DC Adaptor.
4. Plug the DC Adaptor into a switched off power point.
5. Switch the power point on once the DC Adaptor is plugged in. Do not remove or insert the DC Adaptor while the power point is turned on, as this could cause sparking and/or short-circuiting.
6. After painting your nails with each coat of the Gel Nail Polish, place your hand or foot inside the Gel Nail Lamp. Make sure your thumb and all your fingers are relatively flat, or cure your thumb and fingers separately.

Curing options:

• 10 seconds: Press the 10S button to cure small nail art designs, such as dots or lines, or to flash cure Builder Gel.
• 30 seconds: Press the 30S button to cure large nail art designs, such as flowers or checkers.
• 60 seconds: Press the 60S button to cure regular coats of Gel Polish.
• Smart timer: Place your hand inside to auto-start the timer for up to 120 seconds.
• Low heat mode: Press the 99S low heat mode button to cure at 12W for 50 seconds, then 24W for 49 seconds. Use for curing Builder Gel, if you have sensitive nails, or if you experience heat spikes.

Travel Gel Nail Lamp

1. Remove the Gelous Travel Gel Nail Lamp and USB-A to USB-C cable from the packaging.
2. Plug the USB-C end of the cable into the Travel Gel Nail Lamp. Plug the USB-A end of the cable into a wall charger, computer port, laptop port, or power bank.
3. After each coat of Gel Nail Polish, place your hand or foot under the Travel Gel Nail Lamp. If your thumbs do not fit under the Travel Gel Nail Lamp, cure them both separately.

Curing options:

• 60 seconds: Press the power button to cure regular coats of Gel Nail Polish.
• 120 seconds: Hold down the power button to cure thicker coats, such as Rubber Base Coat or Builder Gel.